Bob we had a 600lb billet of steel machined down to a final part of around 150lb, the material cost was massive given traceability, for most of...
Welcome. B17 sounds like an interesting project. I found a lot of the cast parts on the Hurricanes were replaced with machined from billet,...
I saw one of the 'super sized' container ships dock at Felixstowe after being caught in a bad storm. It wasn't nice neat rows ready to be craned...
You are getting awfully close to flask edge with that placement......
As I remember BobS had the splitter as a tractor attachment, I assume that gave him a small amount of distance from the action?
Watching, I think you could work access plates into that but the frame seems it would be 'whippy' without the plate welded in. You are more than...
Didn't want to think the worst but when you have my luck...
For flights and endless beer I might consider it... I take it you have plans to access the jack motor when it goes pffftt. :)
You need a pit to put this in to get a car onto the top deck or am I missing something?
That 3/32 drill you were missing....in all the swarf under there. I regretted not making a cut out under mine before bolting down.
I feel bad you've got a really good wax in a plaster mold that isn't going to work. Please don't underestimate pouring into a POP mould that...
Thanks mywthyt, I was being too delicate.
Only 53 more plates to go and you'll equal Barry Sheen ;) Good to see you on the mend, best wishes with the recovery.
If it's plain POP you may have to do a re-think. Investment plasters are designed for the job, trying to get the chemically bonded water out of...
The mold looks like the pattern invested in plaster. If your planning on burning that out with a torch and pouring into it I would think again....
Separate names with a comma.