Should add, I am in Fairview - Basically, North side of Allen.
I have a couple toyota engine blocks (stripped) and a few heads (most with valves). Way more than I could use for my projects. Also have a 55...
No, but I've heard that. Also have heard of folks using a mix with a small percentage of Hydrogen. I think I'll leave that all to the pros! I...
OK, so this is a month old thread, but I TIG weld AL all the time so I'll chime in. I have a Miller Dynasty 200. For large castings, it takes a...
Yes, they can fail closed (ON). They don't fail often - at work we use good quality ones and have never had a failure other than the associated...
If there were some certifiable standards, like there are for racing helmets, then shops/employers could say "You can use any helmet with a XYZ2017...
We must be running in separate circles! I'm down south (Texas) and I thought we were more lax than average on safety. I know pros from shops...
It could be they were backed up from the Chinese New Year break and are just catching up. The vendors I regularly do stuff with remind me when...
I have used an assortment of helmets. I own two identical Millers. Price really isn't bad. I get replacement outside safety plates (pack of 5...
Use them regularly (1-5 times a month), no issues.
It was marginally too heavy for me to get into the Kiln cold, there was no way (without building some kind of lift), for me to safely get it out...
http://www.govliquidation.com/auction/view?auctionId=12847724&convertTo=USD
I've had no issue with PLA expanding. I have had molds crack when the sand is too fine (325 mesh is useless, 200 works, but will crack a fair...
Nope, sorry not me. I checked with the lady here that handles the invoices. Last time we bought Temp-Mat insulation it was $165/roll. The...
The insulation really is not that expensive by the roll. But we get ours delivered from LaPort I believe so ours comes by truck. I’d think ups...
I’m no expert, but I think if you work alone the lift furnace would have big advantages. If you are doing 2 man pours I would question all the...
Can someone suggest a wax for making filets where we glue PLA parts together?
This is an intercooled supercharger intake for a Lotus Evora. My son’s project, but I casted it from his pla print. While I made sure the...
This one definitely would as it has some flaws. Have decided to re-print/re-cast rather than weld it up. I have re-printed all 4 fittings in a...
What pour temperature do you use? I'd like to play with something like this down the road, but not sure my electric furnace is up to the task. I...
Separate names with a comma.