Thank you
What is the desired temperature of the alloy for casting
Thank you. I will try that as that is my problem
I will post a photo as when I attempt my next casting.
I have made green sand moods The sand is sieved using a fine sieve and the kitty litter is also sieved and adding water. When casting Alliminum...
A 3 Hp motor . This depends weather you want to rip into the turning or just Machining. Also this lathe would have used High speed tool steel . If...
With the styrene do I carve the shape out then mold it in sand then the alliminum melts the styrene.
I have just casted the item in sand and it turned out one hell of a mess. There must be a better way It is that bad it is not worth taking a photo of
This is a photo of my oil burner furnace
This silicon where do I get the silicon from. I noticed you mixed two parts . WhenI make a wax mold and remove from the silicon do I then make a...
The silicon mold . How is this done. The silicon is it from a silicon gun . Can you explain in point step how you do this . This is a new field...
That will not fit my Awning. This is the problem. I think my awning is to old.
Just ok..Explain Iowa to do this process. Thank you
If the item does not pull clean then how do I do it. That is the problem I have .
My casting experience is limited. I am hoping that this forum can help me. My working life is varied Fitter and Turner , Marine Engineer...
If you intend leaving the welder there then it will not last long because steel dust and electrical components do not go well together. The welder...
That lathe is a good buy . There is a lot of work to do , but be patient and be careful as the cast iron that was used in making this machine is...
How do you make a core and what material do you to make it out of. How do you suspend the cor in the sand mold.
It is for my caravan awning . What pictures do you require to help you out
The part comes off the caravan awning. I require 2 . Not a exact replica I have a oil furnace and Ihave made my casting boxes.
Separate names with a comma.