I light my furnace in the same way. with about the same settings as you. :)
Not sure if the 3GPH tip would work if you only feed it 1GPH as the hole in the tip is bigger and it wont spray the same..... as far as I know
It better than I can do. I'm still too much of a wimp to do cast iron. The furnace can do it, it's me that can't.
That is almost the same setup as my hot water blaster. What size tip has the burner got/ going to have? Mine will run a 1gph without smoking from...
I light my oil furnace with a rag.... dipped in oil! It a homemade spray type system (well documented on the AA forum)
When you have time pop round again and I will take my burner apart and show you the inside.... it is so simple it should be easy for you to make....
"Then the rest of the day breaking down some old outboard motor castings, removing metal and plastic fittings from them." I don't bother...
Thanks all. I just need to get some more time to do some castings now. I have taken over the family building business and running the show! Time...
Very nice! I would have thought it would have had a steel wheel, I guess it would be quirter with the rubber one.
Hi All! Im new here but have been on Alloy Ave since the start! If it is sand cast in Alli or brass / bronze I can do it. (most of the time) I...
Separate names with a comma.