Its worth a try, but my issue is with Print2cast, miserable awful stuff, not 3D printing in general. I've lost a lot of motivation to bother...
Interesting....and that was the Print2cast filament?
Hi Jason, thanks for that. I will try some Boric acid, just ordered some. I can't find that resin in Canada and shipping by Fedex is brutal,...
I too have found R&R to be less than helpful. I'm using their Plasticast which is supposed to be better for resins. my 15 year old Ultravest...
Part is just over 1" diameter, cross section of the outer ring is .110" I'm using new R&R Plasticast. Bought it as its supposed to be for...
I see what you mean, not sure either. Here's a close up. Seems to suggest the cavity was flawed before pouring? Or some may some investment...
Will do, just have to get a cured print. I don't think its the printed part, the white in the second photo is just investment not yet cleaned...
The top of button did turn quite black when it cooled. Is that indicative of red brass? Any tricks to casting it, or is it just going to be...
Interesting....I hadn't thought of that. The cured resin is brittle. I'll try it on the next casting, hopefully this weekend. Sorry for...
Hi Everybody, I've been working on investment castings from 3D resin printed patterns. So many variables, I keep trying and learning and getting...
I've got one, or least the identical thing with a different badge. I've used it for bronze and AL and its done all I've asked of it. Being in...
I know its an older post, but for posterity, here's my experience trying it, which in a nutshell was a fail. I've been having an issue with...
Thanks, 15 year old R&R Ultravest. I know they claim its got a one year shelf, but I was told if kept dry its fine. I think the 12 month is from...
Hi Fredo, It might be worth a try as nothing else is working. However I did get a good casting in AL with the identical investment and burn out...
Hi Bill, This will be long, but I'm trying to convey all the info The Siraya cast (purple resin above) instructions are a bit of nightmare....
Hi Bill, Your stuff looks great! Very impressive. Sorry for delayed response, I did find a Canadian distributor for that resin but they are...
Lots going on in my casting trials, months of effort setting up and mastering (cleanly and with no odor) SLA printing. Still have some challenges...
Good idea. I had sent them a note re the Ultra Vest and they've just responded that its good up to 800C/1472F. Also asked about Plastivest,...
older thread, but its prompted a question... Reading R&R's site, they state that resins expand during burn out which can damage the mold....
Nice job on the conveyor. That's the day gig, design build of bulk material handling equipment....I'm late to the party here for any design or...
Separate names with a comma.