Should add, I am in Fairview - Basically, North side of Allen.
I have a couple toyota engine blocks (stripped) and a few heads (most with valves). Way more than I could use for my projects. Also have a 55...
No, but I've heard that. Also have heard of folks using a mix with a small percentage of Hydrogen. I think I'll leave that all to the pros! I...
OK, so this is a month old thread, but I TIG weld AL all the time so I'll chime in. I have a Miller Dynasty 200. For large castings, it takes a...
Yes, they can fail closed (ON). They don't fail often - at work we use good quality ones and have never had a failure other than the associated...
If there were some certifiable standards, like there are for racing helmets, then shops/employers could say "You can use any helmet with a XYZ2017...
We must be running in separate circles! I'm down south (Texas) and I thought we were more lax than average on safety. I know pros from shops...
It could be they were backed up from the Chinese New Year break and are just catching up. The vendors I regularly do stuff with remind me when...
I have used an assortment of helmets. I own two identical Millers. Price really isn't bad. I get replacement outside safety plates (pack of 5...
Use them regularly (1-5 times a month), no issues.
It was marginally too heavy for me to get into the Kiln cold, there was no way (without building some kind of lift), for me to safely get it out...
http://www.govliquidation.com/auction/view?auctionId=12847724&convertTo=USD
I've had no issue with PLA expanding. I have had molds crack when the sand is too fine (325 mesh is useless, 200 works, but will crack a fair...
Separate names with a comma.
