Hi Mark, thanks for the warm welcome! I have been doing a lot of reading, and I'm planning on aluminum for the time being, but I'm going to make...
I'm new to foundry work. I'm a mechanical engineer and I have access to a lot of materials and tools through work, so I thought I'd make a waste...
Thanks Tops, That makes a lot of sense. Instead of haven't seen adjustable height furnace I could make a couple different plinths to keep the...
Hi Tops, I have access to stainless sched 40 and 80 pipe offcuts from work. One project I have in mind is a 12"diameter x 2.5" thick bending die,...
I've been searching on the site and learning a huge amount. I really appreciate how much you are all willing to share. I'm new and designing my...
Separate names with a comma.
