I’m always fascinated and impressed by the surface finishing in sculpture and how it can shift the lens of focus when approaching how you operate...
No ha I appreciate the patience - I was multitasking with some work nonsense and got a little lazy with the outline - I appreciate the advice...
I've done a similar method with two other furnaces over the years but seeing as I'll have a surplus IFB it would likely behoove me to build from...
Defenanlty I snuck this in at the end but definitely worth repeating 95% of melts are Copper/brass/Bronze I was planning on doing most of the...
Good feedback and I'll happily omit the additional hard-faced and just use the fiber blanket. The firebrick is about 3" thick I removed one of...
I’ll probably add the missing components to the smaller one but it’s going to save me a ton of time and $ turning the other into a furnace. It’s...
nah they had all the controllers stripped off
For some reason my post omitted a paragraph but I edited it back in. “I’m about halfway through fabbing up the wheeled frame the furnace will...
I’m in the midsts of converting a kiln into my new furnace and wanted to share some progress. I was actually gifted these two bad boys from a...
I'm running a modified Kwiky burner and always interested in alternative fuel sources and recently I've been looking into pyrolysis chambers that...
Thanks guys, appreciate the kind words. "Are your patterns 100% foam save maybe a little wax and glue?" 100% foam ( well minus a few...
It’s been a few years since I’ve posted and it’s not from a lack of questions or content. Between getting married, buying a house and starting a...
Separate names with a comma.