Thanks for all the input guys, it really was helpful! The muller I was offered, is complete , with the barrow, $500 CDN. It is offered as needing...
yes, I coated it by dipping in a drywall mud slurry a number of times, then allow to dry. Very time consuming, but amazing detail. [ATTACH]
Thanks for the info, I will look into Automation Direct.
Hi Matt, If it were not for Covid I would ask everyone to come visit! Someday!!
I should look into the VFD's, are they good at high load starts? I have one on a mill head on a CNC machine, but it doesn't have to work that...
HT1, I assumed it would be 3 PH and would change motors. But thanks for the heads up on the rubber wheels! I have seen that a lot of the...
Here is the MDF pattern and finished heater ring. It was cast in a one sided sand mold open face, then milled flat. I just wrapped the MDF with...
Thanks Jason, nope don't cast airplanes, just some of the parts for them. Just finished a flap bellcrank mount, design, patterning, casting and...
Thanks for the info Denis. I agree the older mixers will outlast the newer ones, and are available on Kijiji, I bought one for cement for $100....
Some of the stuff I cast. Lost foam pulley. Lots of prep work, successful but too time consuming, then I made a match plate pattern, worked even...
Jeff, I looked at your muller, nice work there! If I can't get the Mulbaro for a good price (including shipping from Montreal) I may go with a...
Do any of you know anything about the B&P Mulbaro Mullers? I was going to start building a muller, I like building stuff, but it always takes...
Hi Guys. First I'm here to learn. I built a small propane furnace a number of years ago (10 maybe) I have done a number of castings, mostly...
Separate names with a comma.
