Do you know if kaowool rigidizer will effect the application process at all or is it still the same? Cause it looked like it was soaking into the...
All in all I'm incredibly happy with how this project has turned out and I learned allot along the way and I'm sure at some point in the disyant...
The fit in the pouring tongs is very secure the lifting ones it is as well if it's seated right but wobbly if it's not I tried to have it so it...
Just bent and welded together some stainless steel scrap rod that was laying around. Hopefully will work really good but only one way to find out....
I went even simpler than those, just simple lift out cups the bottom and lift straight out and basically the same for the pouring tongs and then...
I was just meaning like switch out the floor with the leftover I have before a satanite covering because it got a little crispy from spillage and...
Thank you both for the advice I'll switch out the floor and order some satanite and wait for the other insulation until I need to go with a full...
Any advice on tong design? I think I'm going to go make some new ones soon today. I was thinking just bend the rod into a 3/4 circle to cup and...
What would your opinion on the ITC 100 HT stuff and 2600f wool combo in my previous screenshot? I looked on the website of the place I got the...
100%!! This foundry is already an insane improvement in efficiency! I'm thinking after my energy drink I'm going to go to my work shop and try and...
After learning that I might stick with my old homemade steel tubing crucible for now until I get or make better tongs. Those tongs grip that cup...
That is very good to know.... the way they grip lifting isn't to terrible and its really stable and doesnt tilt as it's got 4 points of contact on...
That is exactly what they are. Very true, they work really good as is just little on the large side for lifting. They are very worn out though and...
That place I found locally had some refractory mortar that was rated for 3000f would that work in place of satanite?
Originally I was going to go with a different insulation option (going to go with my original option when I need to replace) but I found this...
Separate names with a comma.