It works very smooth for now. Its as you probably see two 20mm ID ball bearings mounted to a pipe/tube. I will make some adjustments to keep the...
Thanks! The diameter of the furnace is (if i remember correct) is about 30 cm /12 inches. I am not sure to be honest. The bore is made to suit...
Here are some of the current prints waiting to get cast when i do my first attempt. Its going to be so much failure, but im looking forward to it!...
Hi everyone! I a new member from Norway with lots of different ideas and projects. I joined this forum to get some advice on the casting various...
Separate names with a comma.