Perhaps two parts Talc to one part graphite, then "rumble" in a ball mill for an hour? (What I hope/plan to do here, anyway.)
Sounds like late-80s Imron used at Sunkist. Exeedingly toxic stuff. Seriously durable, though. Needed paint + hardener. I think it was...
Got the rasps in. Will take a pic of the supplies laer today.
Does this come with a Dank Tarn? (From "Ulalume," by Poe - "the dank tarn of Auber")
Bought both an A4 and A6 from Legend, also. They were about 54(?) shipped for the pair. Next is to secure a lid for the smaller one, to help...
Never learned to drink coffee. (I have tried it). Booze is verboten with what I have. Were I to consume it, I might well end up in the hospital.
Got two lacquer brushes today... will do a picture tomorrow AM, assuming I don't forget. This latest immunization - possibly; it could be the...
Just ordered some rasps for balsa shaping. Paid a bit extra for shipping, so as to have them a trifle faster. Hope I get time to work on them...
Yep. Predation.
You need gubbins, don't you? Those little brackets, collars, handles, Knobs, etc? Tobho used lost foam to make his for his Muller... I've used...
Wonders aloud, "how hard would it be to make a (much?) smaller version of that router setup?" Was thinking to use a laminate trimmer, e.g. Bosch...
12-14$ for 5 ounces or so? I think that's what I paid when I bought a small jar at Blick's. (Art supply, downtown Portland)
Speaking of Petrobond - what is a good parting compound? Calcium Carbonate? Talc? Graphite? Mixtures of these? A Commercial material?
I recall him saying it was 140 mesh. That picture tells me plenty. I'll see about getting some as soon as can be managed. I have seen...
That stuff sounds like ersatz Delft Clay - which, based on vids I've seen, needs scratch vents. Also, it uses a higher percentage of binder. I...
Thought ocurs to me that that "Petrobond" might well be "Delft Clay" - which is similar as to makeup, the differences being using silica (?)...
Yes. If there is more than a trace of alumin(i)um in an alloy, it's likely to want A.C. to weld properly. Note that I'm assuming one is using...
Supposedly, Tig-brazing with Aluminum-Bronze wishes A.C.. (as per J. Collier, unless I remember wrongly) Usually, aluminum in such brazing alloys...
KanthAL has *aluminum* in it - probably wants AC...
Like this'n:
Separate names with a comma.
