I make the bulk of my pattens on a 3d printer. I do mostly 1 off's or very limited numbers. If I got into a place where I was doing so many that I...
I'm sure that there's been a post about Kelly's argon degassing lance. but you just need to flow a bit of argon through the molten metal (carbon...
Since you don't have to worry about Cleaning that sand out of a complicated Core you can go heavy on the Sodium Silicate with no real downside (If...
Looks like the right sized handles to match tong rains. If that's the case and they used a tong ring/tong clip to keep the tongs closed that extra...
Tops can you tell me how you oriented your Pin for print? and the infill? I've been working on the design for HT1 and even though the pins are a...
Tobho Mott (David, if this is a secret ballet thing delete this post!)
try updating your bookmark from http://forums.thehomefoundry.org to https://forums.thehomefoundry.org
@HT1 If you can give a couple of stills face on and the side with some dimension's I can get you an STL and or a fusion file. no need to hire me ;)
I moved and built a new shop last year. Now comes the wiring, and getting things out of boxes. But to get it out of the boxes you have to buy or...
Jacob, Welcome to the boards. I noticed on the tech specs that the foaming rate of the LW PLA is dependent on the printing temp. Do you mind...
Hi, Jim. I'm also in Ohio. Which part of Ohio are you in? (I'm in the mid-North East nearest "Big" Town is New Philadelphia (We're south of Canton).
We use nickel Iron Copper brake and fuel lines on some hotrods. I've never ran into any fittings but I'm guessing they make them. Stuff's high...
Kelly is the King of Lost Foam what he recommends about foam best practices is hard earned knowledge. For 1 or 2 parts like this.... I'd go the...
Propane tanks are under pressure so there's no sucking gas out. The valve controls the amount of gas that is allowed to release at a given time....
the stoichiometric ratio (the perfect balance of air to Gas) for propane is 15.6:1 (by mass) That makes it about 4.02% . Propane is picky is...
I think there's an Elegoo with a carbon filter. I haven't tried the newer water based resins. It's been a couple years since I used the resin...
I own both an expensive FDM printer and a cheap $300 resin printer. For ring scale objects or mini figs. The resin is hands down the winner. If I...
I've had good luck with Smooth-On products in the past. Their tech dept seems to do a good job with questions. That Said I'd follow Kelly's...
I've cast some polyurethane bushing parts for suspension before. I'm guessing this part wouldn't be too different. Make your mold (3d printing...
My last compressor (3HP 35Gal tank) was oil free. It worked great for 10-15 years for me.... When it did fail it did it all of a sudden and it...
Separate names with a comma.