What would an addition of silver have on bronze? The most common brazing rods here(and that I have on hand...) seems to have 5% silver (and 5-6% P).
Nice to see others from Sweden, I'm located outside Jönköping. Not very experienced with casting. Have not built a furnace yet, just a hole in...
The blue thing looks like an airspindle for grinding the helix on endmill.
https://bbs.homeshopmachinist.net/forum/general/1959697-replacing-a-bad-yaskawa-vfd-with-a-cheap-import-10hp-single-phase Not very common to...
The usual method is to adjust the tailstock so it cuts parallel, assuming the bed isnt worn.
According to Wikipedia reaching 250C is enough to drive off all water, but I guess it takes quite some time if the oven is at 250C....
Does carbon actually dissolve or does it (like in pack case hardening) diffuse into the melt?
Separate names with a comma.