Just a thought, my experience with high pressure blowers is that the best control happens by restricting the intake rather then the trying to...
I thought I would put in my 2 cents worth here. I process fairly large quantities of aluminum automotive parts into ingots about 7000 lbs per...
I think that you will find it somewhat difficult to get 475kbtu through a 2 " burner with propane or NG. a 2 inch burner normally limits at about...
Wiring diagram for the tilting furnace, this is a Fritzing drawing, I also will share the code if any one wants it. Art B [ATTACH]
The wife went out and helped me video the process, this is a raw video including the finger that kept helping me pour. see the link below...
I do 3 basic size orders 14 lb $55.00, 28 lb $95.00, and 43 lb $130.00, I also have a sliding discount on multiple of the 43 lb boxes. This...
held down, I got tired of hitting the wall. Art b
I direct fire, but i melt 150 to 200 lbs aluminum in 30 minutes without problems, that is burning 5 to 6 gallons per hour roughly 800,000 BTUh...
I ended up moving to Springdale Washington in Stevens county from Spokane to get away from code restrictions, they went to ZERO TOLERANCE air...
When you have the fuel /air correct you will a small amount of flame exiting the furnace/firebox, your picture looks good, you may have a little...
That is very interesting, we also have different fire situation with our foundries in that a spill is not extinguishable until we strip the heat...
gas flow is a product of pressure and orifice size. There are charts available that provide fuel flow with out using metering, Even in...
A burner inside the furnace reduces the amount of air that a naturally aspirated burner can draw due to the back pressure. One of the reasons for...
the flame location in a burner is where the velocity of the fuel mixture slows down to the flame spread rate. The reason the smaller pipe solved...
A properly adjusted burner will put out the same temperature flame as any other properly adjusted burner, if you need higher flame temp as for...
I have been able to wash out the SS on aluminum cast, i pour between 1350 to 1425, I did one pour at 1550 that had some thin spots the SS in that...
thanks David,Rocco that catalyst is the really slow catalyst 75 to 85 minutes, it is the same one that I originally used, what I am trying to do...
I have had good success using both purchase SS and catalyst, the catalyst is expensive and I have only found it in 5 gallon buckets for about...
I didn't make the point I was trying to, The Carbon may be carrying a polarity into the melt, In the Alcoa aluminum plant that shut down about...
I had a 500lb order come in and have been busy the last week or so. In the old days we used mechanical safeties, the failure we were protecting...
Separate names with a comma.
