That makes sense. I’m sure that’s what it is. I couldn’t believe google could be so wrong! Thanks!
Great, thanks! I thought 5% seemed like a lot.
It’s been a while, but I’m finally starting to start a project that will require several lost wax casted parts. The parts need to be dimensionally...
Thanks, I appreciate it. I still can't believe it actually worked.
I'll swing by Friday afternoon. 1:30ish?
Thanks. Yea, It'll be hard to get back to my other projects that don't need castings.
Thanks. It was PLA, in plasticast. Burned out and poured like lost wax, with vacuum assist.
Yea, definitely. When are you around? Not sure about the color.
Well I just finished my first burnout and pour. I am happy to report that it was almost perfect. It went so well, I don't even care I burned my...
Both good points, thanks
Thanks Kelly. Strictly for the point of saving a dime, I'm wanting to use the bricks sparingly. Instead of a solid wall of bricks, I was thinking...
I originally did not use IFB because of the cost. And because I didn't know how to keep them in place. Would it work to bolt them in? I'm thinking...
Oops, my bad. I meant .041, not .061. I used to work at a coorporate jet service center, and yea, .041 is the biggest we used.
The painted surface is between 1 1/4" wool one side (hot side), and 2" of wool on the other side. Yes, I know that's backwards, but that is what...
This is just a burn out oven. And it's running on 120V and pulls under 15amps. Once it cooled down, I opened the door and was shocked at what I...
[ATTACH] Well, I just did a test run of the oven. The controller apperantly has a max limit of 1200F. I was hoping to get to 1300. Hopefully 1200...
Thanks for all the encouragement. And yes, it will be outside.
If all goes well, I should have my first casting attemp mid next week.
Thanks. I did put an inch of wool on the oven floor. I just forgot to get a pic of the complete inside. I will jet everyone know how it works...
Well, it's all done. I did turn it on to make sure it works. I only brought it up to about 120 deg F. I will fully test it out next week. I have...
Separate names with a comma.