Does anyone have a source for raw, unexpanded polystyrene beads?
Well that turned out tpo be a compete disaster! I did a lot of things wrong: didn't sift the sand, shook the bucket but did nto use a vibrator,...
What I am thinking is to make the slurry, warm it up to just the melting point, and inject it into a mold. After it cools, remove the piece from...
I'm needing to make an impeller/propeller with thin parts. Has anyone tried using the pink foam sawdust and mixing it with a low melt wax to make...
Yeah, after going back and looking at your pin router video, I can see that you are going at a much faster rpm. I need to set up a router with...
I'm having bad luck machining pink foam. Using a mill with carbide end mills, running at about 1500 rpm. I'm leaving a lot of attached material...
That puts me on point. Thank you Kelly.
Kelly, I spend hours learning fom your posts. Literally hours. I'm getting ready to build a small table to route (mill) pink foam. I am...
Hey HT1 - Thanks for the quick response. I appreciate you. Wader
I'm looking for an immersion type pyrometer for aluminum. Mifco is "out of stock" an almost everything. Anybody out there that bought one and...
Kelly, If you were using drywall mud to coat these pieces, how did you coat the inside of the tubes?
I did this with a wire cutter with no dimmer switch. And kelly was right, if you slow down at all it just makes a big void at that spot. I'm...
I am looking for a good, fair, supplier of aluminum for casting. I don't want to cut up auto engines and have to deal with the oils, greases and...
Jammer, that is pretty incredible. Thanks for that! Should make my life easier.
Hey Tops and Kelly, yes I think that using a hot wire would work great for the outer diameters of the funnel (4" on one end x 1-3/4" on the other...
One of the pieces I need to make is this discharge nozzle. Other than buying a MillRight I'm unsure how I could make this shape out of foam....
I will be using SiryaTech resin. It is a resin that is used for making molds for plastic injection molding, so yes. it will stand up to the...
Greetings everyone. A newbie here. I have pretty extensive experience in making 3D prints and silicone molds. Now I want to try to make some...
Thanks for the clarification. I guess I just need to spend time on the forum to understand how to use it.
Separate names with a comma.