Been with my homemade rotating-drum muller for about a year now. It works just fine, and I've probably put an average of about 100lbs of petrobond...
[ATTACH] [ATTACH] Really impressed with the detail resolution out of the sand on this one. Cast in C955 Ni-Fe-Al Bronze.
Looking for some safety guidance for alloying bronzes containing manganese. I've been spending a lot of time experimenting with different alloys...
[ATTACH] [ATTACH] [ATTACH] A little project that was requested by a friend of mine. These are made of my homebrew 953 aluminum bronze alloy,...
I'm looking for some guidance on how I can produce reliably strong one-off aluminum castings in a hobbyist foundry setup. At this point I'm fairly...
Looking for some advice on minimizing what I believe to be inclusions of loose sand in the surface of my castings. Some photos displaying what...
Here goes with the question that inspired me to join the forum. Is it feasible to make your own silicon bronze (C87300/Everdur) at home with a...
Hello everybody from the Sunshine State. I'm a hobbyist that started with casting to determine if I could reproduce some silicon bronze fittings...
Separate names with a comma.