Yes a breaking resistor would. But it is a bandsaw. And it does have footbrake if you really needed to stop at fast.
I know the market. Two days ago I just set up this machine. 36 inch wheels. I can get it up to full speed in 15 seconds and it took 90 seconds...
I would really need to get more information like what size is the feeding circuit? Do you know which line has your starting capacitors on? And how...
Kelly, you would adjust the ramp up speed timing. Almost no machine needs to go from zero to full motor rpm in two seconds. There is also a little...
Jason's OK! He's somewhat blunt, to the point. He helps out when applicable. But, he will bluntly say when you're not doing something very kosher....
I like to support anybody's decision in and give some input and clarity. I like to help decide whether it is important for them to choose...
A decent Bridgeport milling machine from the 80s or 90s (with out a DRO) should run you $2000 to $3000 (a steel is a dollar a pound or less)....
I hope wood goes down soon too, as have a deck to do this summer personally. But I'm not holding my breath. Copper and aluminum prices have gone...
I just paid $82 per 4 x 8 sheet three-quarter thick for a basement flooring job. Three sheets. Last year at this time they were $56. The thing...
I only have three recommendations for applications in hi humidity Shoppes with cast surfaces. Johnsons paste wax, WD-40 dry lube with PTFE, and...
They are great machines. One of the foundries that I go to has three or four of them.... But, they are making 3 to 400 patterns a day or pouring...
I had to almost do the exact same process about two years ago with my wife's Lock nut on her tire on her vehicle. The vehicle had aluminum rims. I...
on some older machines that were designed imperial... but have metric thread cutting capacity, the split nut cannot be disengaged. On some of my...
I have spent most of my life in stamping plants. Stamping press requires a floor T stand with two palm buttons at the top of the T separated by 24...
You got 0.001" total travel. That is totally respectable and acceptable.
If you think you're going to move forward with these garden beds, using the timber you have on hand. I would spend $30 on a vapour barrier and...
Creosote, if you can still get it is the best in my opinion. The old pressure treated lumber was the second best. I had raised garden beds built...
Big tap wrenchs are good for big jobs. Back in 2000 I got fed up and built a big one. I want it foldable so it would fit in a standard toolbox...
Congratulations on the new height gauge. That is exactly the one I have wanted for a long time but was never willing to dish out the coin. I have...
What size blade would be on that thing??? My tablesaw takes an 18 inch blade. I am cautiously using it every time with a high level of respect....
Separate names with a comma.