If those are cores, won't the 44U be backwards in the casting?
[MEDIA] This guy shows 3 ways to do it.
I believe this paper concerns the post inoculation of Ductile Iron. They already have ductile iron and are adding the necessary Si to replace what...
[MEDIA] This guy has a lot of great info on motors, controlling speed, Variacs and other stuff.
Do you mean a master alloy, 50/50 AlSi? Silicon has gone up in price, $16 per pound in e-bay. I suppose because of solar panels to save the world....
Someone else will have to answer that. I've not tried to machine it or have any way to try it. I think Aluminum Bronze is the easiest to machine...
You are right HT1, Paw Paw passed from other health issues and wasn't careful. But, if you say that around a group of Blacksmiths, be prepared to...
It comes in ingots, very hard. The NiMg3 sinks to the bottom so the Magnesium bubbles up through the iron to make the carbon nobules. Billy, do...
You don't hold still long enough. :D
French Onion Soup :p
There's an alloy that you inoculate the molten iron with right before pouring. It's Nickle-Mag 3, there are other of the same type but this is the...
Pre-heat them, I poured a small amount of bronze in an Iron pot and it cracked.
Welcome back, what have you been up to?
I had the platinum stuff and it wouldn't set up. I had sprayed the pattern with paint and it reacted to it. Contacted Freeman Supply and they said...
I've got the rubber molds for Civil War soldiers. I think there are 8 of them. I believe they are for pewter, I cast some with lead and it seemed...
Separate names with a comma.
