Does anyone have a source for raw, unexpanded polystyrene beads?
Well that turned out tpo be a compete disaster! I did a lot of things wrong: didn't sift the sand, shook the bucket but did nto use a vibrator,...
What I am thinking is to make the slurry, warm it up to just the melting point, and inject it into a mold. After it cools, remove the piece from...
I'm needing to make an impeller/propeller with thin parts. Has anyone tried using the pink foam sawdust and mixing it with a low melt wax to make...
Yeah, after going back and looking at your pin router video, I can see that you are going at a much faster rpm. I need to set up a router with...
I'm having bad luck machining pink foam. Using a mill with carbide end mills, running at about 1500 rpm. I'm leaving a lot of attached material...
That puts me on point. Thank you Kelly.
Kelly, I spend hours learning fom your posts. Literally hours. I'm getting ready to build a small table to route (mill) pink foam. I am...
Hey HT1 - Thanks for the quick response. I appreciate you. Wader
I'm looking for an immersion type pyrometer for aluminum. Mifco is "out of stock" an almost everything. Anybody out there that bought one and...
Kelly, If you were using drywall mud to coat these pieces, how did you coat the inside of the tubes?
Separate names with a comma.