RANCO-SIL B (30X50) 55 LB BG 44.950 44.95 PREPAID FREIGHT 59.180 59.18 I went ahead and ordered it. Shipping is more than the product but I've...
I'll give it a try. I also RFQ'd some Ranco-Sil. It was $40 for 55 lbs in 2016.
I have not. What is involved in the process? Thanks, Kevin
Pool filter sand does not work. I ran out of Ranco-sil B and found pool sand to be of similar mesh and cheap. 50lbs for $8 at Home Depot. Fired...
I'd gate into the edge of the flange with the runners down and at av45' angle.... How do you recommend I vent it for clean out?
The MAF usually gets eliminated in aftermarket boosted applications. It's just easier to measure elevation at key on and use a MAP. I was...
Measuring what's coming in makes a lot of sense. I've never played with one using a Megasquirt. Practically everything since '96 or earlier has...
This is the motor in my '59. I daily drove this for years with an MS2. No fast idle valve or IAC. I could go outside when it was 8 degrees out,...
I was running fuel and ignition with a Megasquirt 2. I took the VR signal off a late model HEI and fired an MSD box with the MS. This is what I...
I'm still working on the LS intake but I also need some help with the BBC one. None of these castings have been made since you guys helped me out...
I thought I'd give you guys an update. I've been messing with my CNC machine and relearning the CAM software I haven't used in 5 years. Here's a...
AFAIK alcohols are the only thing that dissolves shellac. I don't think modern slurries use alcohol for emissions reasons but something ate my...
I skinned over the holes with shellac and the shellac was smooth. The casting has the layer and support lines visible. Previous castings that I...
I didn't have much luck with paint for smoothing. Now I'm just trying to seal. At least these parts are faster to just sand the metal. My...
Do you guys think dipping the print in latex is a bad idea? The issues from last week's casting seem to have been caused by slurry getting into...
I always used 3m 77 to glue Foamular together. It can gum up cutters. When I used the 80/20 machine, I had a router with 1/8" and 1/4" mills....
I'd like to get back into lost foam. It's been ten years since I played with it. It may be more suitable for making my plenum. I built a 4'...
N2 membranes are out! I put three in series and ran through a sample loop for a few minutes. Mass spec shows 11% O2. I read the article on the...
It's 7.8:1. I run 93. I'm going to have water injection. I going to build for 20 psi, but I have too much time in the paint to put 20 psi in it.
Yes four. 20 psi. The most I've had in it is 8. It's fast enough with 8. It makes 520 N/A. I never put any boost in it on the dyno. It's...
Separate names with a comma.