I re-watched HT1's video, he does mention using it for bronze. I will have to pick up a MIFCO tip and worry about cast iron at a later date. At...
Yes that's correct - I have a k-type with the metal sheath as linked above and that's my primary pyroboy for Aluminum. Would that probe work...
Ok so after an issue with Amazon (package with thermocouple arrived empty?? wtf) I managed to find time to put my S-type pyroboy together [ATTACH]...
Thanks Mark and metallab. I ordered supplies and went with fiberglass insulated copper wire for now for expediency, I will have a look at...
Ok so I am getting ready to order a type S thermocouple probe and a digital meter to go with it, I am seeing that the wire used seems specific to...
At least with a piston engine, burning on the lean side of the stoichiometric ratio means hotter combustion. Too lean = melted pistons Running...
I have purchased ingots of Everdur from Lancaster Foundry Supply in PA.
Your work is inspiring. Good to see you're busy!
Here's another carb adapter, same application for the other one I've posted before (Ford Festiva) but for a Toyota 3k carb. I 3d scanned the...
Too much zinc from diecast scrap. Which has a high shrink rate. Visible in the top of sprue and ingot. There is sand wash present in the mold. The...
Hey I run a forgotten automotive forum, it's largely a labour of love and I understand what it's like. That said, thank you for keeping this place up
Yes - the wood is not ideal. I have looked into HDU (sign foam), renshape, machinable wax, etc. The wood for this scale piece is fine for now, I...
The CNC router is a 24"x 24" unit made by Geometric Robotics https://www.ebay.com/itm/133697164060 I purchased it in 2012 and have made some...
I have used AESUB Blue. It evaporates/sublimates after a period of time (supposed to be no more than 4 hours) out in the field I have found it...
Separate names with a comma.
