It seems to work on my kiln, but stays 10-20c above target temp and it keeps shifting quickly. Not sure if this is considered noise from the...
https://picclick.com/Vulcan-JK-1-Kiln-Ceramic-263551092081.html It’s one of these. It’s not fancy. It’s easy to take apart.
Yea that’s what I was doing. Temp got close to target temp but it kept fluctuating up and down. Since I was looking for precise temps it won’t...
Ok thanks. That helps a lot. I will see what I can do. Unless I can just re wire my kiln to my PID and SSR to get exact temps?
I was trying to use my PID as a plug and play setup. Maybe that’s what’s causing all the problems even with the kiln I have.
Oh darn. I had a friend who used a PID on his hot plate and it worked for him he says. He does not have the same hot plate and did not use the...
I have a syl2352 Auber PID. Auto tune let’s the PID figure what the parameters should be set up all on its own I guess.
mom not sure if my hot plate is a induction type:...
Oh ok. Yes I understand. I left my kiln running even just for 50c temp target, it kept going up down but close but then it got out of auto tune ....
No I never messed with the hysteresis settings. I’m no expert either. I use an SSR and pt100. I don’t understand why cant these PID just keep a...
Anyone know any PID controller for a kiln or any heating hot plate to keep a precise temperature to the decimal and hold it there for days without...
Thanks. I could have bought a more pricier one if I did not spend the money on the wrong one.
Thanks I’ll check it out
I ordered this one: Inkbird PID Temperature Controller with Relay ITC-100VH Thermostat...
Heating. Up to 400c is fine. Pt100 probe only goes to 420c
solid state relay
Hi. Wondering if any one can suggest a PID controller around 30$ or less on Amazon for a 10amp 115v kiln. I know how to setup, I just bought the...
Separate names with a comma.
