For the past few years I have been running the 1HP RoutER11 "link". It has NSK bearings and is speed adjustable (10K-32K) while taking standard...
I also had this problem, I fixed it by setting my browser to force https connections a while back. Seems to work on all my Linux distros and...
Small Update; I finally received my 1,200 degree heat resistant paint and Morgan A12 salamander crucible. Between the postal delays and life it...
Thanks, Waiting on the crucible at this point. Next up I will be spraying it with some bbq spay paint and building my lifting tongs/pouring shank....
Thanks, yeah the drywall paddle worked really well for the min or two my battery drill lasted. I think a corded unit + that paddle would have been...
A bit of productivity today :D I don't have any cardboard tubes or pvc ect. around the place. So for the vent and drain I used what I know and 3d...
I just realized I have not taken the chance to stop in and post a introduction. My apologies. Hello, I am located in WA state. Spokane being...
Today I got everything setup and ready in the shed to mix the refractory and pour the furnace on my next free day. Waiting for a full free day as...
Chazza, I snagged some of these "Link" from a family members craft room last I made a plaque pattern. Just had to snip the pegs off the back. I...
Thank you for the advice everyone, I am learning a lot as I soak in your tips. Reading as much as I can before diving in. You are correct, I did...
I see the original instructions recommend a 3.5" vent hole, would a 4.5" be more appropriate size? I like the idea of running the drain out the...
Some may recognize the furnace kit I will be working on, for those that don't. It came from Lionel from alloyavenue years ago ( I don't think they...
It is good to see these issues. I think you are right, less experienced folks such as myself would have over looked a few of the things you...
Separate names with a comma.
