Just about got it ready to run. I'll worry about painting it later.. [ATTACH]
No problem :cool:
Not sure.. I would look for a used pottery kiln, much cheaper...
These bearings go on the faceplate and do not need to be high precision. The spindle uses split bronze bushings and the spindle shows no evidence...
That is where you'll run into problems. Burn out needs to be pretty controlled for time and temperature for the size of the flask. You might...
You can try it, but the plastic cast is made for casting plastic parts in and I've had very good luck with it... How do you plan to handle the...
Ransome and Randolph plasti cast would be a better investment material to use...
Well.... I can order the SKF bearings here in the US for $125.00 each and have them in less than a week.. Or I can order the same SKF...
Phew we!! I had concerns when I bought this thing that there was an issue with the headstock as there was no positive engagement... Well my...
Eastwood afterblast, spray on and let sit for a minute, scrub with a scotch brite pad, wipe off, repeat. Then buff with oil and a scotch bright...
It's not that bad. I'm only in it for about 3 hours so far. That headstock though... it scares me.. Guess I'll find out tomorrow...
Found this old beast on Facebook marketplace, and the price was right. Going to take a bit to get it up and running again as it has been sitting...
Just wait until you try finding your 10 mm socket... ;)
Ummm. Yes there is.... :cool:
Separate names with a comma.
