Recent Content by John Homer

  1. John Homer
    Thread

    Bronze Ingot Sources

    Can anyone tell me where to purchase ingots of bronze? Looking for silicon bronze or aluminum bronze. Thank you in advance.
    Thread by: John Homer, Jun 27, 2025, 4 replies, in forum: General foundry chat
  2. John Homer
    Post

    Match Plate Runners and Gates

    No core boxes. I will have to make them myself.
    Post by: John Homer, Jun 26, 2025 in forum: Pattern making
  3. John Homer
    Post

    Match Plate Runners and Gates

    This is an original from the match plate I was told.
    Post by: John Homer, Jun 25, 2025 in forum: Pattern making
  4. John Homer
    Post

    Match Plate Runners and Gates

    Post by: John Homer, Jun 25, 2025 in forum: Pattern making
  5. John Homer
    Post

    Match Plate Runners and Gates

    Yes I believe it was used prior. I was thinking the same myself using two sprues. Thank you for your advice.
    Post by: John Homer, Jun 25, 2025 in forum: Pattern making
  6. John Homer
    Thread

    Match Plate Runners and Gates

    [ATTACH] [ATTACH] Question for the group. I have purchased this match plate and would like to know where the recommended sprue should be placed?...
    Thread by: John Homer, Jun 21, 2025, 7 replies, in forum: Pattern making
  7. John Homer
    Post

    Flask Purchase

    What are your prices roughly?
    Post by: John Homer, Nov 22, 2021 in forum: Foundry tools and flasks
  8. John Homer
    Post

    Do you measure metal temperature and how ?

    Thanks for the information. I built as you suggested and it works great. Thanks again
    Post by: John Homer, Sep 5, 2021 in forum: Foundry tools and flasks
  9. John Homer
    Post

    Do you measure metal temperature and how ?

    Got my Mifco thermocouple today. Thanks for the information all
    Post by: John Homer, Aug 23, 2021 in forum: Foundry tools and flasks
  10. John Homer
    Thread

    Machining Question

    Hey guys question so i'm casting my pins which is a half inch pin after casted obviously it cools to a oblong shape and them has to be machined to...
    Thread by: John Homer, Aug 19, 2021, 0 replies, in forum: Castings, finishing/ repair/ and patina's
  11. John Homer
    Post

    Do you measure metal temperature and how ?

    What's the diameter?
    Post by: John Homer, Aug 11, 2021 in forum: Foundry tools and flasks
  12. John Homer
    Post

    Bronze pour time

    Thanks for the information. I watched HT1s video it looked like he puts it in a tube and the end is just sticking out.
    Post by: John Homer, Aug 10, 2021 in forum: Castings, finishing/ repair/ and patina's