I am in the process of designing a small I.C engine. I might not actually build it, it's just a bit of fun. I decided that the engine should have...
Denis, The metal came from a starter motor housing that held the starter motor, badly cracked and even badlier welded numerous years ago. And the...
I found a small pencil drawing done by a late friend of mine, Lorna. It's a view from her previous house from her window or garden, not sure...
Thanks Petee, I did a second casting using modern ZL12 which was much better. It filled all the small areas very well and if it hadn't been...
What does the silicon do to the aluminium? I cast a small picture frame recently using metal from damaged Austin Seven parts circa 1930-ish. Even...
Hi Bruce, I do like experimenting! Do the moulds have to be aluminium or could they be 3D printed? Lee
A portable melting furnace sounds as though it would be gas or oil fired. I like the sound of it either way. Welcome!
Hi JohnyB71, I see you spell aluminium the properly way! Are you in the UK, I am in Cornwall. Hi also to patrin1rka. I have to say that the user...
Hi Chris. I just searched for suspendaslurry here in the UK. Ransom-Randolph seem to sell the range. Artisan foundry sell something similar being...
I tried an experiment recently that worked quite well. I 3D printed some lettering and glued them to a surface then used a 2-part epoxy putty...
I own a 1930 Austin Seven special built in the 1950s. The student who built the body is believed to have used the aluminium skin of a Spitfire...
I had a Renault car aluminium wheel to cut up last year. I used my Bosch jig saw with a coarse wood blade and it cut the wheel up very easily. It...
That's a nice bit of work! I can't help with the moulding, but I am keeping watch for the replies. Good luck.
Separate names with a comma.