Mark's castings's Recent Activity

  1. Mark's castings replied to the thread Experiments with getting the oil furnace to melt iron.

    It's good to know the smaller sizes can be heated higher, I didn't know it was possible to overheat iron :D. I ordered an A6 from Skamol...

    May 29, 2023 at 12:40 AM
  2. Mark's castings replied to the thread Mixing up K-Bond Sand (Similar to Petrobond).

    Nice finish too!.

    May 25, 2023 at 8:02 PM
  3. Mark's castings attached a file to the thread Experiments with getting the oil furnace to melt iron.

    I'm working on a similar theory: the burning fuel has to pass through a narrow gap of about 2.5cm/1" between the crucible and furnace...

    twin helix.jpg May 25, 2023 at 7:20 PM