Pat, I must say I very much appreciate the offer and I'm going to entertain this idea for a minute... How far south are you? My knowledge of the...
Whenever someone who knows things says this it's usually a good time to do what they suggest! I fully acknowledge your points about the debris and...
Thanks for all of the replies everyone. Mark, I am tracking that some machining will be required. My thoughts were if it was open cast it would...
That sounds like a decent learning curve required! I could probably buy cast iron from blackhawk metals (I actually bought some round bar from...
Mate, you are inside my thought cycle at the moment. I just replied to you on the other thread. I had considered purchasing a piece and...
Thanks for the reply mate. I've seen some of the foundry supply companies, and let me assure you I am tempted, however I have enough workshop...
Hello Everyone, I have been sent this way from reddit because someone there suggested that you may be able to help me. I'm looking to have a small...
Hello All, I'm Matt from Brisbane, Australia. I have been sent this way from reddit because someone there suggested that you may be able to help...
Separate names with a comma.
