This furnace is intended to melt a whopping 2 Cu. In. of Aluminum. With the mapp gas as my torch, it shouldn't take too long to get molten metal...
UPDATE My new carburetor for the flask vibrator finally arrived yesterday. Later in the evening, I bolted it up, and this afternoon, I gave it a...
In addition to the layout above, here is the layout for my ingot pouring box, which is also meant to contain sand. I doubt that I will ever clean...
I finally got around to designing and drawing my new shakeout box layout, which is shown below. This layout includes an upper portion for flask...
Normally, I would go to ebay and take a gamble, but I want this engine to run exactly like it was intended to run, with the exception of being...
I am not all that discouraged :) I know that with a new carb, it is going to run perfectly and last for several years, as long as I take care of...
Well thank you :) LOL... Yea, it should be fairly cool :) However, I do need to buy another carburetor :( Oh well, that is just the way it...
I chose my path pretty much out of necessity :) There are certainly much easier and less expensive methods of vibrating the flask, such as the...
6 Gallon Galvanized Steel Flask With 2 Cycle Flask Vibrator Having A Throttle Trigger And Kill Switch Assembly :) [ATTACH] So there it is :)...
Denis Thank you so much for your wonderful documentation and photos. Your effort, work, and attention to detail is really quite impressive :)...
Hello Everyone While digging around for some springs, in my miscellaneous parts box, for my Portable Flask Vibrator, I came across my first...
SNEAK PREVIEW While waiting for my carburetor kit to arrive, which should be Tuesday, I decided to forego the waiting and start assembling the...
PROJECT UPDATE All things considered, I think the weedwacker flask vibrator should ;) eventually work out well, however I have had a setback...
Separate names with a comma.