Maybe I understated my abilities s bit too much. Until my retirement three years ago I was the senior engineer for twenty five years at an...
OK, my misunderstanding. I have thought about making a DIY induction inverter (I have an electronic design background) and that is why I took it...
VFDs output low frequency power for the motors, even though that is made from high frequency switching. The other problem is that you are not just...
This reminds me of a story he wrote in his book Castings Second addition. The author recalls that in the early days of the Cosworth process, a...
lol Now I get it. Not just the taper but also the consistent curve.
Could you explain how you rammed up the horn gate? I have always been confused on how it is done with perpendicular parting planes.
I thought I saw somewhere a use by date on a container of bentone, or listed on a data sheet. Take this with a big grain of salt. I did a quick...
As far as your feeder/risers size, they were too small. For them to be useful they need to solidify after the part you need to cast. If they...
Separate names with a comma.