doesn't look like the pictures posted! I'll have to fix it tomorrow. Sorry PICTURES!
Thanks all for the responses, here is a couple of pictures to help explain my setup. [ATTACH] [IMG] If this worked, that's the setup including...
I'm sorry I didn't explain myself very well, it's a forced air propane burner It uses a 1" pipe, 8" long and "T" where the the gas is feed in...
I am trying to type this on my phone, hopefully it will work. The first problem was I went to melt down some scrap bronze and it wouldn't melt....
Thanks for the reply, Denis. Just one last question, I have been looking at 2 different compressors from Harbor Freight one oil free and one not,...
My next question is does it really take 17 CFM at 90psi? That's a nice compressor, like really, really nice in my world. $3000.00 + ? Are there...
Is there a specific Pneumatic rammer that you would recommend? For the same size of work.
I don't want to sound too stupid but don't all current MAF sensor or any other sensor in the car today use a can protocol? I did try this with...
Thanks Pat. I do want to replace the angle iron lever with a wheel. I like the video, I do need to make a set of bits for brass. Good...
I see I am not the only one making yokes, (ha,ha). I found the drill press would not run slow enough and would stop with the slightest force. I...
OK I know, no pictures its not real so here is a pic of the table [ATTACH] and here is one of the yoke I've been working on. [ATTACH] This is...
Well I have been cast items in bronze and aluminum for about 10 years but I am most definitely still a novice. Spent all last weekend trying to...
Separate names with a comma.