I will have to dig out a rim to see what I have, I do remember that the ones I have are rough like cast iron in the center. More stuff to learn....
How will a person know?
Thanks Petee716
If it dont I will fix it. That wasnt the question . Wasnt an answer.
I see a lot of people using different homemade oil burners but I havent seen anyone using a commercial oil heating unit for their system. Maybe...
Will a piece of clay sewer tile hold up inside an oil fired furnace for melting aluminum?
I guess I havent really went to deep in here to see it all. I will have to do that. I am just getting into melting and my furnace isnt done yet. I...
Maybe you could get something going there. I still dont have my furnace built yet
Someone has to put up something for people to read or this forum will go under . That will be a shame. Been cold and blustry here so havent done...
Thats the starting point Bill. I have some aluminum semi rims to cut up. The measurements on the pipe are 20 inches deep and 14.5 across. Not sure...
Havent been to shop yet to measure pipe yet but I got on ebay and A20 crucibles are high. Does a guy have to use a boughten crucible or can they...
I was just planning on using the insulation to build with. Never thought of using electricity to heat the aluminum with. Would be fun to hear some...
I just remembered I have an old ceramic kiln in the back of an old van out here. Was wondering if they get hot enough to melt aluminum? Dont know...
Thanks Mark Was just curious if anybody could see it working as I did. Sometimes you can find something that is wrong before finishing it. Then it...
I built this thing a few years ago. Before I found this foundry forum. Does this look like it is worth finishing or not. Just want to melt...
Separate names with a comma.
