[ATTACH] [ATTACH]I am doing a rush job and a part broke off! I used some slurry and a little cigar torch and glued it back on. Then slurry.....
This is a restore job of an alter (mutare) crucifix . It will be a pro bono, deus lo vult job. Part A. Fashion matching base. Ok well I could...
[ATTACH] So I picked this up. A friend contacted me about it, so grandpa down the road died 6 years back and his kids fought over it while it...
So I have a friend who brought a tool that he would like cast in aluminum. Since I am a ceramic shell guy, I don't see the use of creating a molds...
This is my first shot at a patina... I made a couple extra's of this guy... so I will try a couple other chemicals later on. It is 'Everdur'...
[ATTACH]
Anyone recommend a spray on laquer?
So while reviewing the Ohio Revised Code of law to see if I can drive with a foot cast on, I found that there are laws governing castings and a...
Any of you use this? https://www.rustoleum.com/product-catalog/consumer-brands/miracle-sealants/clean-maintain/phosphoric-acid-cleaner I am...
So supposably Davinci made a lute(musical guitar) out of a horse skull, casting the hollow skull in silver. I wonder if he did some ninja bone...
So while blowing bubbles on a first dip of suspendaslurry last night I accidentally touched my beard to the piece getting a clump of slurry on my...
This guy who is casting Legos (maybe I should post in the plastic caster forum) looks to just use slurry on the first dip, no silica....
Lancaster Foundry Supply Co. Www.lancasterfoundrysupply.com 2314 Norman road Lancaster PA, 17601 717-394-0753 Owner John Mentzer, 717 two seven...
My son had a birthday today, I ran a pour yesterday, and knowing the timing I added a little hammer, as a present for him today, to my spru before...
Are we going to do it this year? If someone writes up the rules I will participate.
I have been sitting on this sculpture for a while now. My wife brought home a crucifix where the corpus (body) was broken in half. The original...
This should be a quick project... maybe even rushed. This is a sad project that I have been ordered to do. Oddly this is now my 3rd sheep project....
I'm looking to make a burner, what is your favorite set of plans. I was planning on propane as my primary fuel and have the option to add waist...
So I need to add a lot of channels, I'll take any sprue-ing advice. [ATTACH] P.s. Not dead just busy.
What kind of waxes do you use? And where do you get them?
Separate names with a comma.