Hey y'all! I was a long-time user of the former Alloy Avenue going back to 2014/15ish. There, and here, you may call me Razor, Toe, and I also...
I have several crucibles that are just too big for my backyard casting. They measure 7 3/4" OD x 9" high so approximately A16. They are unused...
Hi I've been looking through the website on and off for last month, reading various posts on issues relating to crucibles applications and their...
Did you buy or make your own favorite crucible? Have you used one with a spout that lets you pour the metal from the bottom of the crucible? If it...
This is my first post on this forum, but I've gotten a lot of good advice and information from what others have posted. So, I've decided to post a...
Situation : New , brand new noob. After Creatation of a forge and a furnace. ( Goals) Mission : decide , keep in mind cost, and postage ....
OK, I had to try it. To minimize bifilm generation by using a spout to get the pouring point as close to the basin as possible I put a spout on...
When I started casting I read that stainless steel would not hold up in aluminum service. My first few pours were in a carbon steel crucible and...
Separate names with a comma.
