Feel like I'm on a roll. I accumulated a few patterns during the Winter cold spell and now that Mother Nature has blessed the Midwest with 50-60F...
Been taking advantage of a rare Midwest February heat wave. Here's one I finished up today. [MEDIA] Best, Kelly
Just video for this one fellas. [MEDIA] Best, Kelly
I'm back at it. This is an open plenum single plane intake manifold for running an Inline Autolite carb on a 1969/1970 Boss 302. It retains the...
I'm working on a few new castings but also making some of the routine stuff. It was hot yesterday but I managed four pours. [ATTACH] Original...
I’m coming down the stretch on my induction system project. This is a timing cover to be used with the project described here:...
Spending more time upright and in the shop, and cutting patterns on the router. I put a new dust shoe on it which works much better. [ATTACH]...
Video discussing various methods for constructing lost foam patterns [MEDIA] Best, Kelly
I'd been fielding some questions on my YouTube channel about pattern materials so I put this video together. [MEDIA] Best, Kelly
I joined here yesterday and was aware of this new forum but could not remember the actual name. It's quite hard to find with a Google search....
The is a video of the casting of water necks made from 3d printed patterns and cast in oil bonded sand with sodium silicate cores. [MEDIA]
This is my first try using ceramic shell. I decided to use a part I had printed that I knew would not come out well using the block casting...
This thread is a condensed version of an AA post at the link below where the unabridged version and contributions of others can be found....
Separate names with a comma.
